D* won't set up an install for you until your home construction is complete..the way to go is just have the electrician do it with the rest of the wiring...I do that for a lot of new home construction work that I get. Then all that you have to do is find a good place for your dish to be mounted and route the cable there...it's the most pain free way to get it done.
New Construction...
I am finishing up the prewire on my home and was wondering what I could do to get the 5 RG6’s that I have pulled ready from the dish when the installer puts in the dish. Typically do the installers just breach the “header” under to eve and run the cabling to a weatherproof box. I would like to get the cable outside along with the ground wire. I have access to the grounding pole that the electricians grounded the electrical panel to so I figured I could run that as well to a box outside mounted under the eves along with my 5 RG6’s and have it all ready for the installers. I have ran a conduit through the attic back to my wiring panel in a closet that has the RG6 in it. I was thinking I could get the installers to installl the dish and I could put the multiswiutch in the wiring cabinet and distrubute it from there. So I am looking for a way to get all the cables RG6’s and ground wire outside that the installer can connect too…. If anyone happens to have pictures of something like what I am doing it would be great….Thanks
- Status
- Not open for further replies.
1 - 1 of 8 Posts
1 - 1 of 8 Posts
- Status
- Not open for further replies.
DBSTalk Forum
A forum community dedicated to digital bit streaming enthusiasts. Come join the discussion about programming, content, and reception, home theaters, displays, models, styles, satellites, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
