Joined
·
12,876 Posts
The Sat in jack on the back of the receiver should show either (approximately) 13 vdc or 18 vdc depending on what channel is selected.
The older dish should work just fine. Make sure your coax connectors are properly installed and that you don't have an accidental short of shield to center conductor - very easy to do when installing connectors.
Then set the elevation properly, make sure you mounting mast is plumb, and slowly adjust azimuth around the indicated setting to find a signal.
Carl
The older dish should work just fine. Make sure your coax connectors are properly installed and that you don't have an accidental short of shield to center conductor - very easy to do when installing connectors.
Then set the elevation properly, make sure you mounting mast is plumb, and slowly adjust azimuth around the indicated setting to find a signal.
Carl
