DBSTalk Forum banner
1 - 5 of 5 Posts

·
New Member
Joined
·
2 Posts
Discussion Starter · #1 ·
Looks like the new software broke my remote? I had 3 TVs in one room on different IR remote codes. On the remote, I programmed one receiver to DTV, one to AV1, and one to AV2 slider. Now when I try to slide over and control a tv that's on AV or AV2 it gives me an error that the device can't be control on AV1/2... am I SOL with DTV remote? Am I stuck with 3rd party remote?
 

·
Super Moderator
Joined
·
42,754 Posts
dhogan said:
Looks like the new software broke my remote? I had 3 TVs in one room on different IR remote codes. On the remote, I programmed one receiver to DTV, one to AV1, and one to AV2 slider. Now when I try to slide over and control a tv that's on AV or AV2 it gives me an error that the device can't be control on AV1/2... am I SOL with DTV remote? Am I stuck with 3rd party remote?
You don't say which receivers or version of the software, but I'm still using the slider to control more than one receiver in the same room.
 

·
New Member
Joined
·
2 Posts
Discussion Starter · #4 ·
Receivers only - HR24-200

I actually get an error on the screen that says I can't control it on AV1 or something along those lines. I'm at work, but when I get home i will post exactly what it says. This was working perfectly fine before the software update.
 

·
Registered
Joined
·
17,050 Posts
dhogan said:
Receivers only - HR24-200

I actually get an error on the screen that says I can't control it on AV1 or something along those lines. I'm at work, but when I get home i will post exactly what it says. This was working perfectly fine before the software update.
Are you getting that error on the unit that is setup to be AV1 or one of the other 2?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top