[lgb0250]

Ordered my Nomad from D* yesterday and it arrived today! Great (not).

Unable to set it up and D* has been no help even though I've talked to technical and case management to no avail.

When I hook the nomad up to my router and then plug it in I continue to get a solid amber status light and a blue blinking activity light. No network light at all.

I know this is connected to the internet through my router because I can see it on my router as a connected device. All of my DVR's are connected to the internet and set to "allow" external devices!

I've rebooted my router and still nothing going on with the nomad.

I could seriously use some help here. Thanks.

My setup is an HR34, (2)HR23's and an H23 all connected through a Netgear N900 wireless router.

 

[nike5580]

Have you tried unplugging the power cable from nomad, and plugging it back in? I had an issue with nomad when I first got mine, and it was resolved by a power cycle of nomad.

 

[KenW]

There is also a reset button you can try.

I suppose it could be DOA.

 

[dennisj00]

Also, try a 2 minute reset.

 

[lgb0250]

Finally got it working.

We've seemed to have a power outage everyday recently so I decided to go to each receiver again and go into Advanced Network Setup and make sure I was connecting.

Once I did this the Nomad fired up and appears to have done two firmware updates and now connects. Sorry for the thread. Thanks.

 

[nike5580]

Glad you were able to get it working. Hope you enjoy your new nomad!

 

[retrax]

Mine initially had to sit for a while before it did a firmware update and then it worked fine. I added a 16gb usb memory stick and everything works great.