By using a HDMI Switch can take the HD out from tv1 and send the same picture to another tv.
http://www.monoprice.com/products/subdepartment.asp?c_id=109&cp_id=10110
http://www.monoprice.com/products/subdepartment.asp?c_id=109&cp_id=10110
output HD to second tv from VIP211?
Is that possible. I want to be bale to have my projector on in one room, and the room next it I have a 32" lcd, can I use the output in the rear and still show HD for that other tv?
1 - 7 of 7 Posts
Or you can run component red/green/blue & audio to the second TV.
the way it is now, my projector is hooked via HDMI from the 211 to an Onkyo receiver, will this still work if I run component out and be able to watch both tvs on the same HD feed?boba said:Or you can run component red/green/blue & audio to the second TV.
Yes.projectorguru said:the way it is now, my projector is hooked via HDMI from the 211 to an Onkyo receiver, will this still work if I run component out and be able to watch both tvs on the same HD feed?
Yes, all outputs are always active. The only limitation is that both TVs must support the chosen output resolution.projectorguru said:the way it is now, my projector is hooked via HDMI from the 211 to an Onkyo receiver, will this still work if I run component out and be able to watch both tvs on the same HD feed?
cool thanx fellas, I didn't want to go through the hassel of runnin 35 ft of cable and it not work
1 - 7 of 7 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DBSTalk Forum
A forum community dedicated to digital bit streaming enthusiasts. Come join the discussion about programming, content, and reception, home theaters, displays, models, styles, satellites, reviews, accessories, classifieds, and more!
Full Forum Listing
Recommended Communities
