DBSTalk Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· New Member
Joined
·
4 Posts
Discussion Starter · #1 ·
I have two dishes and four cables. In each dish one cable provides 119 and the other provides 110. I want to install a dp 34 switch to conect four dp receivers. I have two twin dp lnbf.
I have a problem because the dp 34 switch has only 3 input ports. How can I combine
the other two cables to provide 119 and 110 to the third port of the dp 34?
I tried with a dp 21 switch but when run check switch in the third port it indicated not conected.
 

· Hall Of Fame
Joined
·
1,295 Posts
I can't see why you'd need more than 3 inputs (i.e. 3 satellites) in PR. Use the first Dish 500 to point to 119/110. The 119 output goes to the first DP34 input, the 110 output goes to the 2nd DP34 input. The second dish probably points to 61.5. Connect the cable from one output on that dish to the 3rd input on the DP34. Run cables to your receivers, check the dish alignment, and you're done.

And :welcome_s
 

· Beware the Attack Basset
Joined
·
26,573 Posts
865616 said:
I have two dishes and four cables. In each dish one cable provides 119 and the other provides 110. I want to install a dp 34 switch to conect four dp receivers.
Take one cable from each dish and plug it into the DP34.
 

· New Member
Joined
·
4 Posts
Discussion Starter · #4 ·
Mikey said:
I can't see why you'd need more than 3 inputs (i.e. 3 satellites) in PR. Use the first Dish 500 to point to 119/110. The 119 output goes to the first DP34 input, the 110 output goes to the 2nd DP34 input. The second dish probably points to 61.5. Connect the cable from one output on that dish to the 3rd input on the DP34. Run cables to your receivers, check the dish alignment, and you're done.

And :welcome_s
I will try that. Thank you.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top