DBSTalk Forum banner
1 - 4 of 4 Posts

·
New Member
Joined
·
1 Posts
Discussion Starter · #1 ·
oK I just purchased 3 HD receivers. And when I try to install them it would not get pass the verifying configuration screen. It kind of stays there for a while and then a message saying it's not detecting a satellite signal appears. But when I go to signal strength it shows that I'm getting at 95% on ALL the satellite signals. So I'm wondering what to do. HELP ME PLEASE!
 

·
The Shadow Knows!
Joined
·
37,060 Posts
It seems likely that the dish type is wrong. Try going through the satellite setup again and make sure the dish type is correct.

and... :welcome_s!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top