DBSTalk Forum banner

Question about setting up SWM/Whole home

1041 Views 1 Reply 2 Participants Last post by  veryoldschool
I have 2 TVs: 1 HD DVR (HR-24), and one HD (H24) and Whole home. This is connected to a 4 way splitter (Why a 4 way when I have 2 TVS I don't know) I moved around my living room, and didn't know how to set things up again...
I'm a complete NOOB at all of this, so I don't have any fancy terms, nor do I understand them so please reply accordingly.

Aparently I can setup it up 2 different ways? 1:The main wire from the dish to the IN on the splitter, and then another wire from the RED OUT to the "power to swm" on the power supply, then from the "Signal to IRD" a wire goes to the HR-24. And then on the splitter is the other TV.

2 (which is the way I had set it up) The main wire from the Dish to the "Power to SWM" And then the "Signal to IRD" went to the RED IN on the splitter, and the two TVS connected to the splitter.

Both way's seem to work, so what's the difference? I don't remember how the installer had it. What is the "right" way of setting it up? I don't have the "CCK"

1 - 1 of 2 Posts
There may be another half a dozen ways too.

I tend to [I use] your option 2, where there is a splitter between the receivers and the PI. This "might" help as the PI being too close to either the SWiM or a receiver can cause problems.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.