DBSTalk Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

· Cool Member
Joined
·
15 Posts
"A few users have experimented with an SW64 / SW21 cascade on the newer receivers that have 129 on the dish pointing screen. It seems to work but is unstable, requiring a switch check each time the receiver is turned on. Has this been tested? Opinions? "

I have this setup for my 301 & 501. Both seem to be stable but the 301 will go through spurts of the " problem detecting multiswitch screen" but most of the time if I leave it alone it automatically works after about 15 seconds. If that doesn`t work then I go to the point dish screen and see which satellite is only being seen then scroll over and select that satellite and usually it will see the others after selecting the only one it sees. Very rarely do I have to do the complete check switch. And the 501 has never had a problem with the switch set-up since I installed it.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top