DBSTalk Forum banner
1 - 1 of 1 Posts

·
Legend
Joined
·
168 Posts
Davenlr said:
Set the receiver to 480i/native off and the graphic will not appear.
This works but downrezzes the HDMI and component outputs to 480i also, so you will lose your HD.

There is no other "workaround" right now other than staying in HD and converting an HD output (HDMI or component) with an external converter to feed your SD display (unless you can tolerate the 480i resolution on your HD displays).

If you only use one display at a time (HD OR SD), you can pop back-and-forth (between 480 and 1080) by holding the EXIT button down for a few seconds.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top