DBSTalk Forum banner
1 - 3 of 3 Posts

· AllStar
83 Posts
Discussion Starter · #1 ·
i'm running my HR20-700 off of a SWM8 and have been for about 2 months now, with no issues. Just realized I'm getting no signal (0's on all transponders & searching for signal on tuner 1) on Tuner 1, but full strength readings and no problems watching Tuner 2....

any ideas?

· New Member
1 Posts
Try this... disconnect power from all receiver and the SWM.Reconnect the SWM 1st. Reconnect all receiver starting with HDDVR one by one. I did that and is working fine
is possible that you lost power and all receiver start at the same time and the SWM assign the channels wrong let me know if that help..
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.