[loowaters]

I've sifted though about as much of the SWM discussions as I possibly can to find a definitive answer to a pretty simple question. Do I need a splitter if I'm just running this to two receivers? SWM1 runs to the PI and then I send the IRD connection out to my HR22 then I can run SWM2 to my H20 correct? Or is it better to get a 1x2 splitter and run to both receivers off that and terminate the SWM2 connection? I have two legacy receivers as well but those are no brainers. I know it's simple and the answer's around here somewhere I just can't find it.

Loo

 

[veryoldschool]

SWM1 & SWM2 are a splitter. If you only need two outputs, there you go, two outputs.

 

[loowaters]

SWM1 & SWM2 are a splitter. If you only need two outputs, there you go, two outputs.

Thank you. It just seemed that most diagrams didn't use SWM2 so I wanted to clarify.