DBSTalk Forum banner
1 - 2 of 2 Posts

·
New Member
Joined
·
6 Posts
Discussion Starter · #1 ·
I have a VIP 622 thats been working flawlessly. I moved it into the closet and re did the wiring and can't seem to squire a signal. I think I have it hooked up the same. Here it is.

The coax comes in through the wall and I connected it to the input on the triplexer splitter. I then ran two coaxs from sat 1 and 2 on the splitter to the back of the 622 where it says satellite 1 and 2 in. I ran a hdmi from 622 to tv. I left the coax input on the splitter that reads uhf/vhf ch 21-69 unhooked. The tv is picking up the hdmi signal and it is trying to squire the signal which should take 5 mins but its not making any progress.
 

·
New Member
Joined
·
6 Posts
Discussion Starter · #2 ·
Figured it out. Connections were right. I had a splitter before the triplexer. I guess you can't use a splitter before this because I removed it and worked great.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top