DBSTalk Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
DBSTalk Club Member
Joined
·
74 Posts
Discussion Starter · #1 ·
Not sure if this is the right place to post this but since it's for General topics I thought it might fit.

I need to buy an articulating wall mount for a 42" plasma. Most of the ones I've seen run in the $250 to $300 range. Does anyone know of a good place to get one for less?

Thanks in advance!
 

·
Legend
Joined
·
244 Posts
I bought one from Costco for about $91 incldg tax.
It is made by Sanus and is heavy duty.....all steel. Easy install
just make sure if you have to install it into a masonary wall. use
longer Thunderbolts [sleeve type anchors] not the stupid short
shields and lag bolts they supply.
 

Attachments

·
DBSTalk Club Member
Joined
·
74 Posts
Discussion Starter · #4 ·
I've seen AVS Forum before. Should have thought of that. I'll post there as well.

I saw that one at Costco as well digital223. Unfortunately I need one that has an articulating arm that can extend about 24" out and pivot from side to side.

Thanks again.
 

·
Legend
Joined
·
244 Posts
Deuce,
Sorry about that, I didn't read your post correctly.
However you might want to try Monoprice.com. They are
noted for their low prices on cables of any kind. I mean LOW!
I seem to remember that they also carry articulating wall mounts.
Good luck.
 

·
DBSTalk Club Member
Joined
·
74 Posts
Discussion Starter · #6 ·
Thanks for the tip. I'll check on there too.

I did do some research and found one that looks pretty good and not insanely expensive. It's made by Peerless and seems pretty sturdy. Here's a link:

Peerless PLA50-S
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top