DBSTalk Forum banner
1 - 1 of 1 Posts

·
Hall Of Fame
Joined
·
1,837 Posts
Discussion Starter · #1 ·
I have a 625 and the TV2 is located about 50 feet from the receiver. When the box was installed the tech put an extenion piece of coax on the remote antenna to run it out exposed because it was not working good. Up until recently it worked pretty good. Here lately the remote does not work in the same room as TV2. If you go point it directly at the antenna it will work but that is a pain. Any ideas?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top