DBSTalk Forum banner
1 - 3 of 3 Posts

·
New Member
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi

Right now I have one hopper and two joeys. I just bought a hopper on ebay and a duo node. What I am attempting to do is replace the one joey with the new hopper. My question is how do I run the two hoppers and joey from the node? I already ran a second cable from the dish to node sat in, and I have one hopper and two joeys working right now. I am only using one host to hopper and one client to two joeys through a splitter. The hopper will be here in a couple days.

My thoughts are; I will take one cable from the splitter and attache it to the second host, remove the splitter, run one joey to one of the two clients and run the host to the new hopper, use a 75 OHM Terminator on the open ends. Call Dish and have it activated?

This will save me $$$ on installation and I will own a hopper that I can sell later on instead of leasing one for $200.00

Thanks Pain
 

·
New Member
Joined
·
3 Posts
Discussion Starter · #3 ·
Thank you.

That pretty much sums it up. I was concerned that you have to have at lest two joeys? The one joey and two hoppers should not be a problem?

Thanks for your reply..
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top