DBSTalk Forum banner
1 - 2 of 2 Posts

·
Mr. FixAnything
Joined
·
27,526 Posts
I don't think your CarryOut setup has DPP LNBF or DPP switch inside. That means no way to make it by one coax cable. The splitter is special kind and require to be connected to DPP source, because interactive communication from DVR's FW (what has full info what sat/tpn should be feed to particular tuner) to control DPP capable source and select what Lo/Hi band should be send to the splitter/tuner.

Only two cables from the LNBF/dish to your 622 will works if your setup support legacy or DP stack.

Perhaps you could manage to install DPP LNBF instead of existing ? BTW, how many sats it currently see ?
=======================================================================================
Well, after reading its manual ... "toggle" is the key word: as I see it, that means when you switch program what is reside on different sat, the antenna making a move first, mechanical move.
So, using two tuners [what often require signals from different sat] cannot be handled without deep redesign of it (I mean install triple LNBF - for simultaneous reception of all three WA 110/119/129 or DIFFERENT LNBF for EA).

Nope, you can't get it work as it suppose to be, by the DVR's requirement.
 

·
Mr. FixAnything
Joined
·
27,526 Posts
You could try: two variants - one is make second cable; other is change LNBF to DP LNBF with one or two outputs, add DPP33 or DPP44 switch close to the dome, then you could reuse that existing 'splitter'.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top