DBSTalk Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
AllStar
Joined
·
77 Posts
Discussion Starter · #1 ·
Hi,

As I understand the DVR622 VIP from Dish has 480i only TV output. It also comes with a seperate remote to control channels on this output.

I would like to use this output to feed a regular 20" television set that is upstairs in my room. I have two coax lines coming in where the VIP622 is located. One is feeding the signal directly from the antenna, while the second I can use to route the signal back all the way up to the regular analogue TV.

I also notice that the 622 has a second remote, probably to control channels for the secondary TV output. It has a little RF antenna in the back as well.

However, as my 622 is located in the basement and the TV that is going to be hooked up is located 3 stories upstairs, I am afraid that the second remote will not function correctly.

Is there any solution as to how I can change the channels with the second remote upstairs? Maybe something like IR repeater or something similar.

Thanks,
George
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top