DBSTalk Forum banner
1 - 3 of 3 Posts

· New Member
2 Posts
Discussion Starter · #1 ·
A few years back I had my 100+ year old house rewired. While doing so I had the electrician pull two runs of RG6 to each room where I might ever want a TV, and had them all originating from one wiring closet. (He also pulled Cat5e everywhere as well.)

The idea was that I would eventually get around to getting a satellite system and could distribute it all from one central spot, and any changes in the function of a given room could be made without too much effort. The RG6 was Belkin, whatever the type was that was sweep tested for HDTV signals. This Christmas my present to myself and the wife will be a nice HDTV and a dish. Whether it's DirecTV or Dish, I haven't yet decided.

The only acceptable spot for the satellite dish is about 130 feet from the closet, and then some of the runs through the house would add as much as another 30 to 50 feet to the receiver.

Question: can I put in a distribution amplifier (such as a Spaun) in this closet to boost the signal and to select where the signal goes? I asked this of the local Dish Network installer, and he said absolutely not, that it wouldn't work. He could hook up the lead-in cables with barrel connectors, but no amplifier could be in the signal path.

Further question: can such an amplifier/multiswitch be used with DirecTV? If it can, and the Dish guy was correct, that might make my decision for me and I'd go with DirecTV. On the other hand, if the Dish guy was incorrect, maybe I oughta find another Dish guy...

Any and all advice is appreciated.

· Godfather
426 Posts
I think if you re-post your question under DIRECTV installation you'll get your answer. A lot of very knowledgeable Direct TV installers hang out there and I've seen your situation addressed before. I just don't know or remember their answers.

Good luck!

P.S. - Your RG-6 is probably made by Belden, not Belkin.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.