DBSTalk Forum banner
1 - 1 of 1 Posts

·
New Member
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 2005 Media Center PC setup remotely from VIP622 output. Using an IR-RF-IR transceiver between MCE PC and VIP622. VIP622 in single mode. MCE has good tv signal. Problem: MCE recognizes manual setup of IR commands from VIP IR remote, but MCE fails to send working signals to control VIP22 via IR-RF-IR transmitter. Stock VIP remote works with the IR-RF-IR transmitter.

Noticed that there is now no option to slow down the speed of the IR transmission. Think maybe the signals are being sent in fast mode and there is no apparent option to slow them down.

Any suggestions are appreciated!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top